Go to step 11.
NO -
Short to another wire in the front passenger's seat belt tensioner; replace the front passenger's seat belt See: Restraints and Safety Systems/Seat Belt
Systems/Seat Belt/Service and Repair/Front Seat Belt Replacement, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Connect the SRS short canceller (070AZ-SAA0100) to SRS unit connector B (39P) terminals No. 14 and No. 15.
15. Disconnect the simulator lead from the floor wire harness.
16. Measure the resistance between SRS unit connector B (39P) terminals No. 14 and No. 15. There should be an open circuit or at least 1
MOhms.
Is the resistance as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, replace the
SRS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit
Replacement.?
NO -
Short to another wire in the floor wire harness; replace the floor wire harness, then clear the DTC.?
22-8x
SRS DTC Troubleshooting: 22-8x
DTC 22-8x ("x" can be 0 thru 9 or A thru F):
Short to Power in the Front Passenger's Seat Belt Tensioner
Special Tools Required
- SRS Inflator Simulator 07SAZ-TB4011A
- SRS Simulator Lead K 070AZ-SNAA200
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.