Is the voltage as specified?
YES -
Go to step 19.
NO -
Short to power between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7 (floor wire harness, or
ODS unit harness); replace the faulty harness, then clear the DTC.?
19. Replace the ODS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and
Repair/ODS Unit Replacement.
20. Clear the DTCs with the HDS.
21. Check for DTCs with the HDS.
Is the DTC 85-61 or 85-62 indicated?
YES -
Replace the SRS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and
Repair/SRS Unit Replacement.?
NO -
The system is OK at this time.?
85-62
SRS DTC Troubleshooting: 85-61, 85-62
DTC 85-61:
No Signal From the ODS Unit
DTC 85-62:
Incorrect Data From the ODS Unit
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
