Go to step 18.
NO -
Open or increased resistance in the cable reel; replace the cable reel See: Restraints and Safety Systems/Air Bag Systems/Clockspring Assembly /
Spiral Cable/Service and Repair, then clear the DTC.?
18. Turn the ignition switch to LOCK (0).
19. Disconnect the negative cable from the battery, then wait at least 3 minutes.
20. Disconnect SRS unit connector A (39P) from the SRS unit.
21. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the dashboard wire harness 4P
connector.
22. Measure the resistance between the terminals of both SRS simulator leads. There should be less than 1.0 Ohms.
Is the resistance as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector A (39P) and the SRS unit. Check the connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control
Module/Service and Repair/SRS Unit Replacement.?
NO -
Open or increased resistance in the dashboard wire harness; replace the dashboard wire harness, then clear the DTC.?
11-6x
SRS DTC Troubleshooting: 11-3x, 11-6x
DTC 11-3x ("x" can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased Resistance in the Driver's Airbag First Inflator
DTC 11-6x ("x" can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased Resistance in the Driver's Airbag Second Inflator
Special Tools Required
- SRS Inflator Simulator 07SAZ-TB4011A
- SRS Simulator Lead J 070AZ-SNAA100
- SRS Short Canceller 070AZ-SAA0100
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
