Is the resistance as specified?
YES -
Go to step 11.
NO -
Short to ground in the floor wire harness; replace the floor wire harness, then clear the DTC.?
11. Reconnect the negative cable to the battery.
12. Turn the ignition switch to ON (II).
13. Measure the voltage between body ground and SRS unit connector B (39P) terminals No. 26 and No. 27 individually. There should be less
than 0.2 V.
Is the voltage as specified?
YES -
Go to step 14.
NO -
Short to power in the floor wire harness; replace the floor wire harness, then clear the DTC.?
14. Turn the ignition switch to LOCK (0).
15. Connect the SRS inflator simulator (jumper connector) and the black SRS simulator lead (A) of simulator lead L to the floor wire harness 2P
