7. Connect the SRS inflator simulator (2 Ohms connectors) and simulator lead J to the dashboard wire harness 4P connector.
8. Reconnect the negative cable to the battery.
9. Clear the DTCs with the HDS.
10. Check for DTCs with the HDS.
Is DTC 12-3x or 12-6x indicated?
YES -
Go to step 11.
NO -
Short to another wire in the front passenger's airbag first or second inflator; replace the front passenger's airbag See: Restraints and Safety
Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Front Passenger's Airbag Replacement, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Disconnect SRS unit connector A (39P) from the SRS unit.
14. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the dashboard wire harness 4P
connector.
15. Connect the SRS short cancellers (070AZ-SAA0100) to SRS unit connector A (39P) terminals No. 5 and No. 6 and No. 9 and No. 10.
16. Measure the resistance between the terminals of both SRS simulator leads. There should be an open circuit or at least 1 MOhms.
Is the resistance as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector A (39P) and the SRS unit. Check the connection between the connector and the SRS
