Is there continuity?
YES -
Repair a short in the wires between the appropriate suspension stroke sensor and the active damper control unit.?
NO -
Go to step 14.
14. Check for continuity between active damper control unit connector B (14P) terminal No. 11 and appropriate suspension stroke sensor 3P
connector terminal No. 3 (see table).
Is there continuity?
YES -
Go to step 16.
NO -
Repair an open in the wire between the appropriate suspension stroke sensor and the active damper control unit.?
15. Turn the ignition switch to LOCK (0).
16. Reconnect all connectors.
17. Remove the appropriate suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and
Switches - Suspension/Ride Height Sensor/Service and Repair. Do not disconnect the sensor connector.
18. Start the engine, and wait 5 seconds.
19. Check the SUS STROKE_S VOLTAGE (RF), or (RR) in the ACTIVE DAMPER SYSTEM DATA LIST with the HDS while moving the
suspension stroke sensor arm through a complete stroke. Compare the voltage/rotation angle between the chart and the measurements.
