NOTE: The voltage should increase (decrease) within 90 degrees of the sensor arm rotation from the first voltage change point.
Is the voltage as specified?
YES -
Go to step 20.
NO -
Replace the appropriate suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and
Switches - Suspension/Ride Height Sensor/Service and Repair.?
20. Clear the DTC with the HDS.
21. Turn the ignition switch to LOCK (0).
22. Start the engine, and wait 5 seconds.
23. Check for DTCs with the HDS.
Is DTC 2-1, or 2-3 indicated?
YES -
Substitute a known-good active damper control unit and retest. If the DTC goes away, replace the original active damper control unit See: Relays
and Modules/Relays and Modules - Steering and Suspension/Relays and Modules - Suspension/Suspension Control Module/Service and Repair.?
NO -
Troubleshooting is complete.?
2-2
Active Damper System DTC Troubleshooting: 2-2
DTC 2-2:
Left-front Suspension Stroke Sensor Circuit High Voltage
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0).
4. Start the engine, and wait 5 seconds.
5. Check for DTCs with the HDS.
