1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 32-3x indicated?
YES -
Go to step 4.
NO -
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?
4. Turn the ignition switch to LOCK (0).
5. Disconnect the negative cable from the battery, then wait at least 3 minutes.
6. Disconnect the floor wire harness 2P connector (A) from the front passenger's side airbag (B).
7. Connect the SRS inflator simulator (2 Ohms connectors) and simulator lead L to the floor wire harness.
8. Reconnect the negative cable to the battery.
9. Clear the DTCs with the HDS.
10. Check for DTCs with the HDS.
Is DTC 32-3x indicated?
YES -
Go to step 11.
NO -
Short to another wire in the front passenger's side airbag inflator; replace the front passenger's side airbag See: Restraints and Safety Systems/Air
Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Side Airbag Replacement, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the floor wire harness 2P
connector.
15. Connect the SRS short canceller (070AZ-SAA0100) to SRS unit connector B (39P) terminals No. 8 and No. 9.
16. Measure the resistance between the terminals of the black SRS simulator lead (A). There should be an open circuit or at least 1 MOhms.
