Go to step 15.
NO -
Replace the floor wire harness, then clear the DTC.?
15. Substitute a known-good side impact sensor.
16. Exchange the left side impact sensor (second) for the impact sensor prepared in step 15.
17. Reconnect the negative cable to the battery.
18. Clear the DTCs with the HDS.
19. Turn the ignition switch to ON (II), then wait for 10 seconds.
20. Check for DTCs with the HDS.
Is DTC 45-11 indicated?
YES -
Go to step 21.
NO -
Faulty left side impact sensor (second); replace the left side impact sensor (second) See: Restraints and Safety Systems/Air Bag Systems/Impact
Sensor/Service and Repair/Side Impact Sensor (Second) Replacement, then clear the DTC.?
21. Turn the ignition switch to LOCK (0).
22. Disconnect the negative cable from the battery, then wait at least 3 minutes.
23. Return the impact sensor which was replaced in step 16.
24. Substitute a known-good side impact sensor.
25. Exchange the left side impact sensor (first) for the impact sensor prepared in step 24.
26. Reconnect the negative cable to the battery.
27. Clear the DTCs with the HDS.
28. Turn the ignition switch to ON (II), then wait for 10 seconds.
29. Check for DTCs with the HDS.
Is DTC 45-11 indicated?
YES -
Go to step 30.
NO -
Faulty left side impact sensor (first); replace the left side impact sensor (first) See: Restraints and Safety Systems/Air Bag Systems/Impact
Sensor/Service and Repair/Side Impact Sensor (First) Replacement, then clear the DTC.?
30. Turn the ignition switch to LOCK (0).
31. Disconnect the negative cable from the battery, then wait at least 3 minutes.
32. Disconnect SRS unit connector B (39P) from the SRS unit.
33. Disconnect the floor wire harness 4P connector from the left side impact sensor (first) See: Restraints and Safety Systems/Air Bag
Systems/Impact Sensor/Service and Repair/Side Impact Sensor (First) Replacement.
34. Disconnect the floor wire harness 2P connector from the left side impact sensor (second) See: Restraints and Safety Systems/Air Bag
Systems/Impact Sensor/Service and Repair/Side Impact Sensor (Second) Replacement.
35. Measure the resistance between floor wire harness 2P connector (left side impact sensor (second)) terminals No. 1 and No. 2. There should
be an open circuit or at least 1 MOhms.
