DTC 3-7:
Yaw Rate-Lateral/Longitudinal Acceleration Sensor Range/Performance Problem (Wheel Speed Signal-Longitudinal Acceleration Signal Incorrect
Correlation)
DTC 3-9:
Yaw Rate-Lateral/Longitudinal Acceleration Sensor Malfunction (Longitudinal Acceleration Sensor)
DTC 3-A:
Yaw Rate-Lateral/Longitudinal Acceleration Sensor Malfunction
NOTE: If DTC 8-6 is stored at the same time as DTC 3-1, DTC 3-3, DTC 3-6, DTC 3-7, DTC 3-9, or DTC 3-A, troubleshoot DTC 8-6 first, then
recheck for DTC 3-1, DTC 3-3, DTC 3-6, DTC 3-7, DTC 3-9, or DTC 3-A.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0).
4. Test-drive the vehicle around a corner for 2 seconds or more.
5. Check for DTCs with the HDS.
Is DTC 3-1, 3-3, 3-6, 3-7, 3-9, or 3-A indicated?
YES -
Go to step 6.
NO -
Intermittent failure, the system is OK at this time. Check for poor or loose connections between the yaw rate-lateral/longitudinal acceleration sensor
and the active damper control unit.?
6. Check for VSA system DTCs with the HDS See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
Is any DTC indicated?
YES -
Go to the indicated VSA system DTC's troubleshooting.?
NO -
Go to step 7.
7. Turn the ignition switch to LOCK (0).
8. Substitute a known-good yaw rate-lateral/longitudinal acceleration sensor See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Yaw Rate Sensor/Service and Repair.
9. Turn the ignition switch to ON (II).
10. Clear the DTC with the HDS.
11. Turn the ignition switch to LOCK (0).
12. Test-drive the vehicle around a corner for 2 seconds or more.
13. Check for DTCs with the HDS.
Is DTC 3-1, 3-3, 3-6, 3-7, 3-9, or 3-A indicated?
YES -
Replace the active damper control unit See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and Modules -
Suspension/Suspension Control Module/Service and Repair.?
