YES -
There is a short in the wires between the HandsFreeLink control unit and the audio-navigation unit. Replace the affected shielded harness.?
NO -
Go to step 13.
13. Check for continuity between the HandsFreeLink control unit 28P connector and audio-navigation unit connector C (28P) according to the
table.
Is there continuity?
YES -
Replace the HandsFreeLink control unit See: Accessories and Optional Equipment/Cellular Phone/Communications Control Module/Service and
Repair.?
NO -
There is an open in the wire(s) between the audio-navigation unit and the HandsFreeLink control unit. Replace the affected shielded harness.?
2706
Navigation System DTC Troubleshooting: 2706
DTC 2706:
Gyro Diag ECU Temp XX 掳C
NOTE:
- Check the vehicle battery condition first See: Starting and Charging/Battery/Testing and Inspection/Component Tests and General
Diagnostics/Battery Test.
- This navigation DTC sets when the audio-navigation unit YAW sensor's temperature is out of its specified range.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the general troubleshooting information See: Accessories and Optional Equipment/Navigation
System/Testing and Inspection/Initial Inspection and Diagnostic Overview/How to Troubleshoot the Navigation System.
- Do this test only when the vehicle cabin temperature is between -4 掳F (-20 掳C) and 158 掳F (70 掳C).
1. Clear the hard error code.
2. Turn the ignition switch to LOCK (0), and then back to ON (II).
3. Go into the Diagnostic Menu, and select the Self-Diagnosis Mode in the Select Diagnosis items menu See: Accessories and Optional
Equipment/Navigation System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Navigation System Diagnostic Mode.
