5. Turn the ignition switch to LOCK (0).
6. Start the engine.
7. Do the DAMPER FORCE OPERATION TEST in the FUNCTIONAL TESTS MENU with the HDS.
8. Check for DTCs with the HDS.
Is DTC 5-5, 5-6, 5-7, or 5-8 indicated?
YES -
Go to step 9.
NO -
Intermittent failure, the system is OK at this time. Check for poor or loose connections between the damper coil and the active damper control
unit.?
9. Turn the ignition switch to LOCK (0).
10. Disconnect active damper control unit connector A (20P) See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays
and Modules - Suspension/Suspension Control Module/Service and Repair.
11. Turn the ignition switch to ON (II).
12. Measure the voltage between body ground and the appropriate active damper control unit connector A (20P) terminal.
Is there battery voltage?
YES -
Repair a short to power in the wire between the appropriate damper coil and the active damper control unit, then go to step 18.
NO -
Go to step 13.
13. Turn the ignition switch to LOCK (0).
14. Measure resistance between the appropriate active damper control unit connector A (20P) terminals (see table).
