Is the resistance as specified?
YES -
Disconnect and reconnect the connector, and then check DTC again. If the problem is still present, replace the SRS unit See: Relays and
Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit Replacement.
NO -
Open in the floor wire harness between the right side impact sensor (first) and the right side impact sensor (second); replace the floor wire harness,
then clear the DTC.?
42. Turn the ignition switch to LOCK (0).
43. Check the connections between SRS unit connector B (39P) and the SRS unit, and between the floor wire harness 4P connector and the
right side impact sensor (first) See: Restraints and Safety Systems/Air Bag Systems/Impact Sensor/Service and Repair/Side Impact Sensor
(First) Replacement and between the floor wire harness 2P connector and right side impact sensor (second) See: Restraints and Safety
Systems/Air Bag Systems/Impact Sensor/Service and Repair/Side Impact Sensor (Second) Replacement.
Are the connections OK?
YES -
Go to step 44.
NO -
Replace the floor wire harness, then clear the DTC.?
44. Substitute a known-good side impact sensor.
45. Exchange the right side impact sensor (first) for the impact sensor prepared in step 44.
46. Reconnect the negative cable to the battery.
47. Clear the DTCs with the HDS.
48. Turn the ignition switch to ON (II), then wait for 10 seconds.
49. Check for DTCs with the HDS.
Is DTC 44-11 indicated?
