Is the connection OK?
YES -
Go to step 7.
NO -
Repair the poor connection and retest. If DTC 81-61 or 81-62 is still present, go to step 7.
7. Disconnect the ODS unit harness 18P connector (A) from the ODS unit (B).
8. Turn the ignition switch to ON (II).
9. Measure the voltage between body ground and ODS unit harness 18P connector terminal No. 1. There should be battery voltage.
Is there battery voltage?
YES -
Go to step 10.
NO -
Open in the right engine compartment wire harness, floor wire harness, or ODS unit harness; replace the faulty harness, then clear the DTC.?
10. Turn the ignition switch to LOCK (0).
11. Measure the resistance between body ground and ODS unit harness 18P connector terminal No. 12. There should be less than 1.0 Ohms.
