Is there continuity?
YES -
Repair a short to ground in the wire.?
NO -
Go to step 10.
10. Check for continuity between power tilt/telescopic steering control unit connector A (16P) terminals No. 7, No. 6, No. 10, No. 14, and No.
15 and power tilt/telescopic steering switch 13P connector terminals No. 1,No. 7,No. 3,No. 10, and No. 6 respectively.
Is there continuity?
YES -
Replace the power tilt/telescopic steering control unit.?
NO -
Repair an open in the wire.?
B1836
DTC Troubleshooting: B1836
DTC B1836:
Power Seat Position Sensor Circuit Short
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTC with the HDS.
2. Turn the ignition switch to LOCK (0) and then back to ON (II).
