3. Operate the power seat adjustment switch in all direction for at least 6 seconds each.
4. Check for DTCs with the HDS.
Is DTC B1836 indicated?
YES -
Go to step 5.
NO -
Intermittent failure, the system is OK at this time. Check for loose or poor connections at the power sear control unit connectors.?
5. Turn the ignition switch to LOCK (0).
6. Disconnect power seat control unit connector A (40P).
7. Disconnect the 4P connectors from the slide position sensor, the front up-down position sensor, and the rear up-down position sensor, and
disconnect the 8P [14P] connector from the driver's seat subharness.
[ ]: With seat ventilation
8. Check for continuity between power seat control unit connector A (40P) terminal No. 15 and body ground.
Is there continuity?
YES -
Repair a short to ground in the wire.?
NO -
Go to step 9.
9. Check for continuity between body ground (motor body) and terminal No. 1 of the slide position sensor, the front up-down position sensor,
and the rear up-down position sensor.
Is there continuity?
YES -
Replace the motor/position sensor that has continuity.?
NO -
Go to step 10.
10. Check for continuity between body ground (seat frame) and terminal No. 8 [No. 12] of the driver's seat subharness 8P [14P] connector.
[ ]: With seat ventilation
Without seat ventilation
