Is DTC B1000 also indicated?
YES -
Troubleshoot DTC B1000.?
NO -
Intermittent failure, the system is OK at this time. Check for loose or poor connections at the MICU and B-CAN connected units in the table.?
B1152
DTC Troubleshooting: B1152
DTC B1152:
Gauge Control Module Internal Error (EEPROM error)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0), and then back to ON (II).
3. Wait for at least 6 seconds.
4. Check for DTCs with the HDS.
Is DTC B1152 indicated?
YES -
Replace the gauge control module See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and Repair.?
NO -
Intermittent failure, the system is OK at this time.?
B1155
DTC Troubleshooting: B1155, B1156
DTC B1155:
Gauge Control Module Lost Communication with Combination Switch Control Unit (HLSW Message)
DTC B1156:
Gauge Control Module Lost Communication with Combination Switch Control Unit (WIPSW Message)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0), and then back to ON (II).
3. Wait for at least 6 seconds.
4. Check for DTCs with the HDS.
Is DTC B1155 and/or B1156 indicated?
