Is there about 5 V or more?
YES -
Repair a short to power in the wire harness.?
NO -
Update the SH-AWD control unit if it does not have the latest software See: Powertrain Management/Transmission Control Systems/Relays and
Modules - Transmission and Drivetrain/Relays and Modules - Differential/Control Unit/Testing and Inspection/SH-AWD Control Unit Update, or
substitute a known-good SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission
and Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair, and recheck. If the symptom/indication goes away with the
updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit,
replace the original SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and
Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair.?
42-1x
SRS DTC Troubleshooting: 42-1x
DTC 42-1x ("x" can be 0 thru 9 or A thru F):
No Signal From the Right Front Impact Sensor
Special Tools Required
- SRS Inflator Simulator 07SAZ-TB4011A
- SRS Simulator Lead L 070AZ-SNAA300
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 42-1x indicated?
YES -
Go to step 4.
NO -
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?
4. Turn the ignition switch to LOCK (0).
5. Disconnect the negative cable from the battery, then wait at least 3 minutes.
6. Check the connections between SRS unit connector A (39P) and the SRS unit, between the right engine compartment wire harness 2P
