SRS DTC Troubleshooting: 42-2x, 42-8x, 42-9x, 42-Ax, 42-Bx
DTC 42-2x, 42-8x, 42-9x, 42-Ax, 42-Bx ("x" can be 0 thru 9 or A thru F):
Internal Failure of the Right Front Impact Sensor
NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair and General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 42-2x, 42-8x, 42-9x, 42-Ax, or 42-Bx indicated?
YES -
Faulty right front impact sensor; replace the right front impact sensor See: Restraints and Safety Systems/Air Bag Systems/Impact Sensor/Service
and Repair/Front Impact Sensor Replacement, then clear the DTC. If the DTC is still present, replace the SRS unit See: Relays and
Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit Replacement.?
NO -
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?
43
Adaptive Cruise Control (ACC) DTC Troubleshooting: 43
DTC 43:
Cal FL Brake System Malfunction
NOTE: In this troubleshooting, you will operate the ADAPTIVE CRUISE CONTROL (ACC) BRAKE (brake actuator 3) continuously four or five
times using the FUNCTION TEST with the HDS. During this operation, the VSA modulator-control unit may stop working. This means the VSA
modulator-control unit has shut down to protect the system from overheating during continuous operation.
If the VSA modulator-control unit stops working, wait for a few minutes until the VSA modulator-control unit cools down, then restart the
troubleshooting.
1. Check for VSA system DTCs with the HDS.
Are any DTCs indicated?
YES -
Troubleshoot the indicated VSA system DTC(s).?
NO -
Go to step 2.
2. Start the engine, and press the MAIN switch ON.
3. Clear the DTCs with the HDS.
4. Select ADAPTIVE CRUISE CONTROL (ACC) from the DRIVING SUPPORT menu, then enter the FUNCTION TEST.
5. Activate BRAKE ACTUATOR 3 from the FUNCTION TEST menu.
6. Watch the ACC indicator.
Does the ACC indicator come on?
