NOTE: Drive the vehicle on the road, not on a lift.
8. Check for DTCs with the HDS.
Is DTC 21, 22, 23, or 24 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 46P connector. If the VSA modulator-control unit was updated, substitute a
known-good VSA modulator-control unit See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Traction Control
Module/Testing and Inspection. If a known-good VSA modulator-control unit was substituted, replace the appropriate hub bearing unit if it has not
been replaced.
- RFreoanr:t :R Reepplalaccee t hthee r feraorn ht uhbu bb ebaerainrign gu nuint i tS eSee:e S: tSeteereinrign ga nadn dS uSsupsepnesniosino/nS/tSeteereinrign/gF/rFornotn St tSeteereinrign gK Knuncukclkel/eS/eSrevrivciec ea nadn dR eRpeapiar.i?r.?
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the
original VSA modulator-control unit See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Traction Control
Module/Testing and Inspection. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.?
22-1x
SRS DTC Troubleshooting: 22-1x, 22-2x
DTC 22-1x ("x" can be 0 thru 9 or A thru F):
Open in the Front Passenger's Seat Belt Tensioner
DTC 22-2x ("x" can be 0 thru 9 or A thru F):
Increased Resistance in the Front Passenger's Seat Belt Tensioner
Special Tools Required
- SRS Inflator Simulator 07SAZ-TB4011A
- SRS Simulator Lead K 070AZ-SNAA200
- SRS Short Canceller 070AZ-SAA0100
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 22-1x or 22-2x indicated?
YES -
Go to step 4.
NO -
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?
4. Turn the ignition switch to LOCK (0).
5. Disconnect the negative cable from the battery, then wait at least 3 minutes.
6. Remove the B-pillar lower trim, then disconnect the floor wire harness 4P connector (A) from the front passenger's seat belt tensioner.
