Install a TPMS type wheel, and memorize the sensor ID. Drive the vehicle above 15 mph (24 km/h) for 40 continuous seconds, or memorize the
ID with the HDS See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure Sensor/Testing and Inspection.?
3. Turn the ignition switch to LOCK (0).
4. Turn the ignition switch to ON (II).
5. Check TPMS DATA LIST for RF, LF, RR, or LR TIRE PRESSURE SENSOR SIGNAL STATUS changing to NORMAL with the HDS.
NOTE: If UNDEFINED is shown on the sensor transmitter status, turn the ignition switch to LOCK (0), rotate the tire 1/4 turn, then turn the
ignition switch to ON (II), and try again. If UNDEFINED is still displayed, repeat this procedure until NORMAL is shown.
Is NORMAL indicated within one full turn of the tire?
YES -
The system is OK at this time. Clear the DTC with the HDS.?
NO -
Go to step 6.
6. Substitute a wheel with a known-good tire pressure sensor on the vehicle.
7. To memorize the sensor ID, drive the vehicle above 15 mph (24 km/h) for 40 continuous seconds, or memorize the ID with the HDS See:
Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure Sensor/Testing and Inspection.
8. Turn the ignition switch to LOCK (0).
9. Turn the ignition switch to ON (II).
10. Check TPMS DATA LIST for RF, LF, RR, or LR TIRE PRESSURE SENSOR STATUS changing to NORMAL with the HDS.
NOTE: If UNDEFINED for sensor status, turn the ignition switch to LOCK (0), rotate the tire 1/4 turn, then turn the ignition switch to ON (II), and
try again. If UNDEFINED is still displayed, repeat this procedure until NORMAL is shown.
Is NORMAL indicated within one full turn of the tire?
YES -
Replace the tire pressure sensor on the client's wheel See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure
Sensor/Service and Repair.?
NO -
Go to step 11.
11. Turn the ignition switch to LOCK (0).
12. Substitute an initiator from a known-good location on the current vehicle, or from another known-good vehicle See: Instrument Panel,
Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure Monitor Receiver / Transponder/Service and Repair.
13. Turn the ignition switch to ON (II).
14. Check TPMS DATA LIST for RF, LF, RR, and LR TIRE PRESSURE SENSOR STATUS changing to NORMAL with the HDS.
NOTE: If UNDEFINED is shown on the sensor transmitter status, turn the ignition switch to LOCK (0), rotate the tire 1/4 turn, then turn the
ignition switch to ON (II), and try again. If UNDEFINED is still displayed, repeat this procedure until NORMAL is shown.
