Tuesday, April 28, 2020

2010 Acura Truck MDX V6-3.7L Page 595


NOTE:



- An overcharging alternator can cause this DTC.



- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.



1. Turn the ignition switch to ON (II).



2. Clear the DTC with the HDS.



3. Test-drive the vehicle at 2 mph (3 km/h) or more.



4. Check for DTCs with the HDS.



Is DTC 62 indicated?



YES -



Check for a poor connection at the battery terminals. Check for a loose connection at G303. If the connections are good, go to the Alternator and



Regulator Circuit Troubleshooting See: Starting and Charging/Charging System/Testing and Inspection/Component Tests and General



Diagnostics/Alternator and Regulator Circuit Troubleshooting.?



NO -



Intermittent failure, the system is OK at this time. Check for loose terminals at the VSA modulator-control unit 46P connector. Check for a loose



connection at G303. Refer to intermittent failures troubleshooting.?



62-1x



SRS DTC Troubleshooting: 62-1x



DTC 62-1x ("x" can be 0 thru 9 or A thru F):



Open in the Front Passenger's Seat Belt Buckle Switch



NOTE:



- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and



Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and



Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and



Charging/Battery/Service and Repair/Procedures.



- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS



unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,



and retest.



1. Clear the DTCs with the HDS.



2. Turn the ignition switch to ON (II), then buckle and unbuckle the front passenger's seat belt several times.



3. Check for DTCs with the HDS.



Is DTC 62-1x indicated?



YES -



Go to step 4.



NO -



Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the



DTC.?



4. From the HDS Main menu, select SRS, then PARAMETER INFORMATION. In the PARAMETER INFORMATION Menu, select Buckle



Switch, Seat Position Sensor and check the status on the HDS screen for FRONT LEFT SEAT BELT BUCKLE SWITCH when the seat belt



is buckled, and unbuckled.



- If UNBUCKLED is indicated only when the front passenger's seat belt is unbuckled, go to step 5.



- If BUCKLED is indicated only when the front passenger's seat belt is buckled, go to step 11.



- If OPEN is indicated only when the front passenger's seat belt is buckled and unbuckled, go to step 18.



5. Turn the ignition switch to LOCK (0).