13. Vehicles with ACC: Disconnect E-Pretensioner unit connector B(14P) from the E-Pretensioner unit See: Restraints and Safety Systems/Seat
Belt Systems/Seat Belt Tensioner/Service and Repair/Removal and Replacement.
14. Disconnect SRS unit connector B (39P) from the SRS unit.
15. Measure the resistance between body ground and SRS unit connector B (39P) terminal No. 1. There should be an open circuit or at least 1
MOhms.
Is the resistance as specified?
YES -
Go to step 17.
NO -
Short to ground between SRS unit connector B (39P) terminal No. 1 and the ODS unit harness 18P connector terminal No. 7 (right engine
compartment wire harness, floor wire harness, or ODS unit harness); replace the faulty harness, then clear the DTC.?
16. Reconnect the negative cable to the battery.
17. Turn the ignition switch to ON (II).
18. Measure the voltage between body ground and SRS unit connector B (39P) terminal No. 1. There should be less than 0.2V.
Is the voltage as specified?
YES -
Go to step 19.
NO -
Short to power in the harness between SRS unit connector B (39P) terminal No. 1 and the ODS unit 18P connector terminal No. 7 (floor wire
harness or ODS unit harness); replace the faulty harness, then clear the DTC.?
19. Turn the ignition switch to LOCK (0).
20. Measure the resistance between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7. There
should be less than 1.0 Ohms.
