Is the resistance as specified?
YES -
Go to step 37.
NO -
Short to ground in the floor wire harness between the right side impact sensor (first) and the right side impact sensor (second); replace the floor
wire harness, then clear the DTC.?
37. Reconnect the negative cable to the battery.
38. Turn the ignition switch to ON (II).
39. Measure the voltage between body ground and floor wire harness 2P connector (right side impact sensor (second)) terminals No. 1 and No. 2
individually. There should be less than 0.2 V.
Is the voltage as specified?
YES -
Go to step 40.
NO -
Short to power in the floor wire harness between the right side impact sensor (first) and the right side impact sensor (second); replace the floor
wire harness, then clear the DTC.?
40. Turn the ignition switch to LOCK (0).
41. Measure the resistance between floor wire harness 4P connector (right side impact sensor (first)) terminals No. 1 and No. 4 and floor wire
harness 2P connector (right side impact sensor (second)) terminals No. 1 and No. 2. There should be less than 1.0 Ohms.
