Go to step 5.
NO -
Intermittent failure, the system is OK at this time. Check for loose or poor connections.?
5. Check for DTCs with the HDS.
Is DTC B1841 also indicated?
YES -
Go to step 17.
NO -
Go to step 6.
6. Clear the DTCs with the HDS.
7. Turn the ignition switch to LOCK (0) and then back to ON (II).
8. Operate the tilt switch for 2 seconds, and check the tilt motor operation.
Does the tilt motor run smoothly?
YES -
Go to step 9.
NO -
Go to step 26.
9. Turn the ignition switch to LOCK (0).
10. Disconnect power tilt/telescopic steering control unit connector A (16P).
11. Disconnect the power tilt motor/position sensor 8P connector.
12. Check for continuity between power tilt/telescopic steering control unit connector A (16P) terminals No. 4, No. 12, and No. 16 and power
tilt motor/position sensor 8P connector terminals No. 6, No. 7, and No. 8 respectively.
