Tuesday, October 30, 2018

Disclaimer***Acura Truck RDX AWD L4-2.3L Turbo Technical Service Bulletin # 10-027 Date: 110617


Disclaimer***Acura Truck RDX AWD L4-2.3L Turbo Technical Service Bulletin # 10-027 Date: 110617



Audio System - Door/Rear Shelf Speakers Distorted/Rattle



10-027



June 17, 2011



Applies To:



See VEHICLES AFFECTED



Door or Rear Shelf Speakers Rattle, or Sound Is Distorted



(Supersedes 10-027, dated August 3, 2010, to revise the information marked by the black bars and asterisks)



*REVISION SUMMARY



^ Under VEHICLES AFFECTED, the VIN range for the 2010 TL ALL with navigation was changed.



^ Descriptions of the speakers were added to VEHICLES AFFECTED and PARTS INFORMATION.



^ Under PARTS INFORMATION, part numbers were added for TL with navigation.*



SYMPTOM



There is a rattle or distorted sound in at least one of the speakers in the doors or the rear shelf.



PROBABLE CAUSE



The speaker damper is faulty.



73



*VEHICLES AFFECTED*



CORRECTIVE ACTION



Replace the affected speakers.



PARTS INFORMATION



Front door and rear door speakers:



RDX - P/N 39120-STK-A12



Front door and rear shelf speakers:



TL without navigation - P/N 39120-STK-A12



Front door and rear shelf speakers:



TL with navigation - P/N 39120-TK4-A51



*Rear door speakers:



TL with navigation - P/N 39120-TK4-A11*



WARRANTY CLAIM INFORMATION



The normal warranty applies.



NOTE:



There are separate warranty numbers depending on which side of the vehicle you begin. For example, if you replace the left front speaker, then



the right, use OP # 012100 and combo code A to file your warranty claim.



74



RDX



TL



Failed Part: P/N 39120-TK4-A51



Defect Code: 03217



Symptom Code: 03220



Skill Level: Repair Technician



DIAGNOSIS



Do the speaker check mode to isolate the faulty speaker(s):



1. Turn the ignition switch to ON (II).



2. Make sure the audio system is turned off.



3. Push and hold the No.1 and No.3 preset buttons.



4. While holding the preset buttons, push the PWR knob to on.



5. Release the buttons and the speaker check mode begins. A test tone should sound from one speaker as indicated on the display.



6. Each time you press the SEEK/SKIP CATEGORY button, the test moves to the next speaker.



7. The speaker check mode ends when you turn the audio unit off, or turn the ignition switch to LOCK (0).



REPAIR PROCEDURE



Replace the applicable speaker(s):



^ Refer to the audio section of the appropriate service manual, or



^ Online, under Search by Vehicle, enter keywords SPEAKER REPLACE and select Speaker Test/ Replacement from the list.