6. Turn the ignition switch to ON (II), then wait for 10 seconds.
7. Measure the voltage between ODS unit harness 2P connector terminal No. 1 and No. 2. There should be more than 6 V.
Is the voltage as specified?
YES -
Faulty inner side front passenger's weight sensor; replace the inner side front passenger's weight sensor See: Restraints and Safety Systems/Air Bag
Systems/Seat Occupant Sensor/Service and Repair, then clear the DTC.?
NO -
Open in the ODS unit harness; replace the ODS unit harness, then clear the DTC, and retest. If the DTC is still present, replace the ODS unit See:
Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/ODS Unit Replacement.?
82-13
SRS DTC Troubleshooting: 82-13
DTC 82-13:
No Signal From the Inner Side Front Passenger's Weight Sensor
NOTE:
- Before doing this troubleshooting procedure review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair and General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- These SWS DTCs are cleared by turning the ignition switch to LOCK(0).
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 82-13 indicated?
YES -
Faulty inner side front passenger's weight sensor; replace the inner side front passenger's weight sensor See: Restraints and Safety Systems/Air Bag
Systems/Seat Occupant Sensor/Service and Repair, then clear the DTC.?
