7. Connect the SRS inflator simulator (2 Ohms connectors) and simulator lead L to the floor wire harness.
8. Reconnect the negative cable to the battery.
9. Clear the DTCs with the HDS.
10. Check for DTCs with the HDS.
Is DTC 34-8x indicated?
YES -
Go to step 11.
NO -
Short to power in the right side curtain airbag inflator; replace the right side curtain airbag See: Restraints and Safety Systems/Air Bag
Systems/Air Bag/Service and Repair/Removal and Replacement/Side Curtain Airbag Replacement, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the floor wire harness 2P
connector.
15. Reconnect the negative cable to the battery.
16. Turn the ignition switch to ON (II).
17. Measure the voltage between body ground and each terminals of the black SRS simulator lead (A) individually. There should be less than 0.2
V.
Is the voltage as specified?
