7. Connect the SRS inflator simulator (2 Ohms connectors) and simulator lead L to the floor wire harness.
8. Reconnect the negative cable to the battery.
9. Clear the DTCs with the HDS.
10. Check for DTCs with the HDS.
Is DTC 32-8x indicated?
YES -
Go to step 11.
NO -
Short to power in the front passenger's side airbag inflator; replace the front passenger's side airbag, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the floor wire harness 2P
connector.
15. Reconnect the negative cable to the battery.
16. Turn the ignition switch to ON (II).
17. Measure the voltage between body ground and each terminals of the black SRS simulator lead (A) individually. There should be less than 0.2
V.
Is the voltage as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, replace the
