Is there continuity?
YES -
Repair a short in the wires between rear differential fluid temperature sensor 2P connector terminals No. 1 and No. 2.?
NO -
Go to step 12.
12. Reconnect all connectors.
13. Update the SH-AWD control unit if it does not have the latest software See: Powertrain Management/Transmission Control Systems/Relays
and Modules - Transmission and Drivetrain/Relays and Modules - Differential/Control Unit/Testing and Inspection/SH-AWD Control Unit
Update, or substitute a known-good SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules
- Transmission and Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair.
14. Start the engine.
15. Let the engine idle 1 minute.
16. Check for DTCs with the HDS.
Is DTC 43-1 indicated?
YES -
Replace the rear differential fluid temperature sensor See: Powertrain Management/Transmission Control Systems/Sensors and Switches -
Transmission and Drivetrain/Sensors and Switches - Differential/Differential Temperature Sensor/Switch/Service and Repair.?
NO -
Replace the original SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and
Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair.?
43-1x
SRS DTC Troubleshooting: 43-1x, 45-1x
DTC 43-1x ("x" can be 0 thru 9 or A thru F):
No Signal From the Left Side Impact Sensor (first)
DTC 45-1x ("x" can be 0 thru 9 or A thru F):
No Signal From the Left Side Impact Sensor (second)
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
