Sunday, April 26, 2020

2010 Acura Truck MDX V6-3.7L Page 454


44-11



SH AWD DTC Troubleshooting: 44-11



DTC 44-11:



SH-AWD Control Unit



NOTE: Before you troubleshoot, review the general troubleshooting information See: Transmission and Drivetrain/Differential Assembly/Testing



and Inspection/Initial Inspection and Diagnostic Overview.



1. Turn the ignition switch to ON (II).



2. Clear the DTC with the HDS.



3. Turn the ignition switch to LOCK (0), then turn the ignition switch back to ON (II).



4. Check for DTCs with the HDS.



Is DTC 44-11 indicated?



YES -



Update the SH-AWD control unit if it does not have the latest software See: Powertrain Management/Transmission Control Systems/Relays and



Modules - Transmission and Drivetrain/Relays and Modules - Differential/Control Unit/Testing and Inspection/SH-AWD Control Unit Update, or



substitute a known-good SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission



and Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair, and recheck. If the symptom/indication goes away with the



updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit,



replace the original SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and



Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair.?



NO -



Intermittent failure, the system is OK at this time.?



44-12



SH AWD DTC Troubleshooting: 44-12



DTC 44-12:



SH-AWD Relay Stuck ON



NOTE: Before you troubleshoot, review the general troubleshooting information See: Transmission and Drivetrain/Differential Assembly/Testing



and Inspection/Initial Inspection and Diagnostic Overview.



1. Turn the ignition switch to ON (II).



2. Clear the DTC with the HDS.



3. Start the engine.



4. Check for DTCs with the HDS.



Is DTC 44-12 indicated?



YES -



Go to step 5.



NO -



Intermittent failure, the system is OK at this time.?



5. Turn the ignition switch to LOCK (0).



6. Remove the SH-AWD relay See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and



Drivetrain/Relays and Modules - Differential/Actuator Relay/Service and Repair, then test the SH-AWD relay See: Power and Ground



Distribution/Testing and Inspection/Power Relay Test.?



Is the SH-AWD relay OK?