Is there battery voltage?
YES -
Repair a short to power in the wire between the appropriate damper coil and the active damper control unit, then go to step 18.
NO -
Go to step 13.
13. Turn the ignition switch to LOCK (0).
14. Measure resistance between the appropriate active damper control unit connector A (20P) terminals (see table).
Is the resistance between 0.6-2.0 Ohms?
YES -
Check for loose terminals in the active damper control unit connector A (20P). If the terminals are OK, replace the active damper control unit
See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and Modules - Suspension/Suspension Control Module/Service
and Repair, then go to step 19.
NO -
Go to step 15.
15. Disconnect the appropriate damper coil 2P connector.
16. Check for continuity between the appropriate active damper control unit connector A (20P) terminal and appropriate damper coil 2P
connector terminal No. 1 (see table).
