Is the resistance as specified?
YES -
Disconnect and reconnect the connector, and then check DTC again. If the problem is still present, replace the SRS unit See: Relays and
Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit Replacement.?
NO -
Open in the floor wire harness between the SRS unit and the left side impact sensor (first); replace the floor wire harness, then clear the DTC.?
43-2x
SRS DTC Troubleshooting: 43-2x, 43-8x, 43-9x, 43-Ax, 43-Bx
DTC 43-2x, 43-8x, 43-9x, 43-Ax, 43-Bx ("x" can be 0 thru 9 or A thru F):
Internal Failure of the Left Side Impact Sensor (first)
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair and General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 43-2x, 43-8x, 43-9x, 43-Ax, or 43-Bx indicated?
YES -
Faulty left side impact sensor (first); replace the left side impact sensor (first), then clear the DTC. If the DTC is still present, replace the SRS unit
See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit Replacement
.?
NO -
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?
