7. Turn the ignition switch to ON (II).
8. Measure the voltage between body ground and ODS unit harness 18P connector terminal No. 1. There should be battery voltage.
Is there battery voltage?
YES -
Go to step 9.
NO -
Open between the No. 2 (7.5 A) fuse in the auxiliary under-dash fuse holder 2 and the ODS unit harness 18P connector terminal No. 1 (right engine
compartment wire harness, floor wire harness, or ODS unit harness); replace the faulty harness, then clear the DTC.?
9. Turn the ignition switch to LOCK (0).
10. Measure the resistance between body ground and ODS unit harness 18P connector terminal No. 12. There should be less than 1.0 Ohms
Is the resistance as specified?
YES -
Go to step 11.
NO -
Open in the wire harness between ODS unit harness 18P connector terminal No. 12 and body ground (G605) (floor wire harness, or ODS unit
harness) or poor connection at G605; if the connection is OK, replace the faulty harness, then clear the DTC.?
11. Disconnect the negative cable from the battery, then wait at least 3 minutes.
12. Vehicles with ACC: Disconnect E-Pretensioner unit connector B(14P) from the E-Pretensioner unit See: Restraints and Safety Systems/Seat
