Is the resistance as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector A (39P) and the SRS unit. Check the connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control
Module/Service and Repair/SRS Unit Replacement.?
NO -
Short to another wire in the dashboard wire harness; replace the dashboard wire harness, then clear the DTC.?
11-4x
SRS DTC Troubleshooting: 11-1x, 11-2x, 11-4x, 11-5x
DTC 11-1x ("x" can be 0 thru 9 or A thru F):
Open in the Driver's Airbag First Inflator
DTC 11-2x ("x" can be 0 thru 9 or A thru F):
Increased Resistance in the Driver's Airbag First Inflator
DTC 11-4x ("x" can be 0 thru 9 or A thru F):
Open in the Driver's Airbag Second Inflator
DTC 11-5x ("x" can be 0 thru 9 or A thru F):
Increased Resistance in the Driver's Airbag Second Inflator
Special Tools Required
- SRS Inflator Simulator 07SAZ-TB4011A
- SRS Simulator Lead J 070AZ-SNAA100
NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and
Disarming/Service and Repair, General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection See: Starting and
Charging/Battery/Service and Repair/Procedures.
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS
unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,
and retest.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to ON (II), then wait for 10 seconds.
3. Check for DTCs with the HDS.
Is DTC 11-1x, 11-2x, 11-4x, or 11-5x indicated?
