Is there continuity?
YES -
Repair a short in the wires.?
NO -
Go to step 13.
13. Reconnect driver's MPCS unit connector A (40P).
14. Turn the ignition switch to ON (II).
15. Measure the voltage between driver's door wire harness A 16P connector terminal No. 4 and body ground.
Is there about 5 V?
YES -
Replace the left power mirror.?
NO -
Replace the driver's MPCS unit.?
B2183
DTC Troubleshooting: B2183
DTC B2183:
Left Power Mirror Vertical Sensor Signal Error
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back to ON (II).
3. Move the left power mirror in each direction with the power mirror switch.
4. Check for DTCs with the HDS.
Is DTC B2183 indicated?
