Is there continuity?
YES -
Repair a short to ground in the wire.?
NO -
Go to step 23.
23. Reconnect power tilt/telescopic steering control unit connector A (16P).
24. Turn the ignition switch to ON (II).
25. Measure the voltage between power tilt/telescopic steering control unit connector A (16P) terminals No. 2 and No. 16.
Is there battery voltage when the telescopic switch is operated?
YES -
Faulty power telescopic motor/position sensor, replace the telescopic motor assembly.?
NO -
Replace the power tilt/telescopic steering control unit.?
26. Turn the ignition switch to LOCK (0).
27. Disconnect power tilt/telescopic steering control unit connector B (8P).
28. Disconnect the power telescopic motor/position sensor 6P connector.
29. Check for continuity between power tilt/telescopic steering control unit connector B (8P) terminals No. 4 and No. 6 and power telescopic
motor/position sensor 6P connector terminals No. 1 and No. 2 respectively.
