Is the voltage as specified?
YES -
Replace the active damper control unit See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and Modules -
Suspension/Suspension Control Module/Service and Repair.?
NO -
Replace the appropriate suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and
Switches - Suspension/Ride Height Sensor/Service and Repair.?
2-8
Active Damper System DTC Troubleshooting: 2-8, 2-A
DTC 2-8:
Right-front Suspension Stroke Sensor Signal Circuit Low Voltage
DTC 2-A:
Right-rear Suspension Stroke Sensor Signal Circuit Low Voltage
NOTE: If DTC 8-2 is stored at the same time as DTC 2-8 or DTC 2-A, troubleshoot DTC 8-2 first, then recheck for DTC 2-8 and DTC 2-A.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0).
4. Start the engine, and wait 5 seconds.
5. Check for DTCs with the HDS.
Is DTC 2-8, or 2-A indicated?
YES -
Go to step 6.
NO -
Intermittent failure, the system is OK at this time. Check for poor or loose connections between the suspension stroke sensor and the active
damper control unit.?
6. Turn the ignition switch to LOCK (0).
7. Disconnect the appropriate suspension stroke sensor 3P connector.
