Friday, February 14, 2020

2010 Acura Truck MDX V6-3.7L Page 471


35. Measure the resistance between floor wire harness 2P connector (left side impact sensor (second)) terminals No. 1 and No. 2. There should



be an open circuit or at least 1 MOhms.



Is the resistance as specified?



YES -



Go to step 36.



NO -



Short to another wire in the floor wire harness between the left side impact sensor (first) and the left side impact sensor (second); replace the floor



wire harness, then clear the DTC.?



36. Measure the resistance between body ground and floor wire harness 2P connector (left side impact sensor (second)) terminals No. 1 and No.



2 individually. There should be an open circuit or at least 1 MOhms.



Is the resistance as specified?



YES -



Go to step 37.



NO -



Short to ground in the floor wire harness between the left side impact sensor (first) and the left side impact sensor (second); replace the floor wire



harness, then clear the DTC.?



37. Reconnect the negative cable to the battery.



38. Turn the ignition switch to ON (II), then wait for 10 seconds.



39. Measure the voltage between body ground and floor wire harness 2P connector (left side impact sensor (second)) terminals No. 1 and No. 2



individually. There should be less than 0.2 V.