Belt Systems/Seat Belt Tensioner/Service and Repair/Removal and Replacement.
13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Measure the resistance between body ground and SRS unit connector B (39P) terminal No. 1. There should be an open circuit or at least 1
MOhms.
Is the resistance as specified?
YES -
Go to step 15.
NO -
Short to ground between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7 (floor wire harness, or
ODS unit harness); replace the faulty harness, then clear the DTC.?
15. Measure the resistance between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7. There
should be less than 1.0 Ohms.
Is the resistance as specified?
YES -
Go to step 16.
NO -
Open in the wire harness between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7 (floor wire
harness, or ODS unit harness); replace the faulty harness, then clear the DTC.?
16. Reconnect the negative cable to the battery.
17. Turn the ignition switch to ON (II).
18. Measure the voltage between body ground and SRS unit connector B (39P) terminal No. 1. There should be less than 0.2 V.
