connector terminal No. 1.
Is there continuity?
YES -
Go to step 14.
NO -
Repair an open in the wire between the left-rear suspension stroke sensor and the headlight leveling control unit.?
14. Reconnect the headlight leveling control unit 16P connector.
15. Reconnect the active damper control unit connector B (14P).
16. Start the engine, and wait 5 seconds.
17. Measure voltage between body ground and left-rear suspension stroke sensor 3P connector terminal No. 1.
Is there about 5 V?
YES -
Replace the suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and Switches -
Suspension/Ride Height Sensor/Service and Repair.?
NO -
Check the headlight leveling control system. If necessary, substitute a known-good headlight leveling control unit.?
2-C
Active Damper System DTC Troubleshooting: 2-C
DTC 2-C:
Right-rear/Left-rear Suspension Stroke Sensor Incorrect Correlation
1. Turn the ignition switch to LOCK (0).
2. Check that the right-rear and left-rear suspension stroke sensors are properly mounted See: Sensors and Switches/Sensors and Switches -
Steering and Suspension/Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair, and check for bent to damaged sensor
links.
NOTE: After troubleshooting for the left side suspension stroke sensor, do the headlight initial position learning procedure See: Lighting and
Horns/Testing and Inspection/Programming and Relearning.
