20. Check TPMS DATA LIST for RF, LF, RR, and LR TIRE PRESSURE SENSOR SIGNAL STATUS changing to NORMAL with the HDS.
NOTE: If the HDS screen shows UNDEFINED for sensor status, turn the ignition switch to LOCK (0), rotate the tire 1/4 turn, then turn the ignition
switch to ON (II), and try again. If UNDEFINED is still displayed, repeat this procedure until NORMAL is shown.
Is NORMAL indicated within one full turn of the tire?
YES -
Replace the tire pressure sensor on the client's wheel See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure
Sensor/Service and Repair.?
NO -
Go to step 21.
21. Turn the ignition switch to LOCK (0).
22. Disconnect the appropriate initiator 3P connector.
23. Disconnect the TPMS control unit 20P connector See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire
Pressure Module/Service and Repair.
24. Check for continuity between TPMS control unit 20P connector terminal No. 20 and the appropriate initiator 3P connector terminal No. 1.
