6. Check that the ACC indicator comes on, and then goes off.
Does the ACC indicator go off?
YES -
Go to step 7.
NO -
Go to the ACC system's general troubleshooting information See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading
and Clearing Diagnostic Trouble Codes.?
7. Turn the ignition switch to LOCK (0).
8. Disconnect E-pretensioner unit connector B (14P) from the E-pretensioner unit See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt Tensioner/Service and Repair/Removal and Replacement.
9. Disconnect the ACC unit 20P connector from the ACC unit See: Cruise Control/Cruise Control Module/Service and Repair.
10. Check for continuity between E-pretensioner unit connector B (14P) terminals No. 3 and No. 5 and ACC unit 20P connector terminals No. 10
and No. 20.
Is there continuity?
YES -
Go to step 12.
NO -
Open in the right engine compartment wire harness or the dashboard wire harness or the floor wire harness; repair the faulty harness, then clear the
DTC.?
11. Jump the SCS line with the HDS See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes.
NOTE: This step must be done to protect the PCM from damage.
12. Disconnect these connectors:
- PCM connector A (49P) See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and Repair.
- Gauge control module connector A (12P) See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service
and Repair.
- VSA modulator-control unit 46P connector See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Traction
Control Module/Service and Repair.
- Yaw rate-lateral/longitudinal acceleration sensor 4P connector See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Yaw Rate Sensor/Service and Repair.
- Steering angle sensor 5P connector See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Column
