13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the floor wire harness 2P
connector.
15. Measure the resistance between body ground and each terminals of the black SRS simulator lead (A) individually. There should be an open
circuit or at least 1 MOhms.
Is the resistance as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, replace the
SRS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit
Replacement.?
NO -
Short to ground in the floor wire harness; replace the floor wire harness, then clear the DTC.?
Adaptive Cruise Control
Adaptive Cruise Control (ACC) DTC Troubleshooting: 34, 35, 36
DTC 34:
Master Cylinder Brake Fluid Pressure Sensor Circuit Open/Short
DTC 35:
Master Cylinder Brake Fluid Pressure Sensor Center Position Error
DTC 36:
Master Cylinder Brake Fluid Pressure Sensor Shift Error
1. Clear the DTCs with the HDS.
2. Watch the ACC indicator.
Does the ACC indicator go off?
YES -
Intermittent failure, the system is OK at this time. Check for loose or poor connections.?
NO -
Go to step 3.
3. Press the brake pedal.
4. Watch the ACC indicator.
