Is the resistance as specified?
YES -
Go to step 12.
NO -
Open in the floor wire harness or ODS unit harness, or poor connection at the ODS unit harness 18P connector and the ODS unit. Check the ground
connection at G605. Check the connection; if the connection is OK, replace the faulty harness, then clear the DTC.?
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Vehicles with ACC: Disconnect E-Pretensioner unit connector B(14P) from the E-Pretensioner unit See: Restraints and Safety Systems/Seat
Belt Systems/Seat Belt Tensioner/Service and Repair/Removal and Replacement.
14. Disconnect SRS unit connector B (39P) from the SRS unit.
15. Measure the resistance between body ground and SRS unit connector B (39P) terminal No. 1. There should be an open circuit or at least 1
MOhms.
Is the resistance as specified?
YES -
Go to step 17.
NO -
Short to ground between SRS unit connector B (39P) terminal No. 1 and the ODS unit harness 18P connector terminal No. 7 (right engine
compartment wire harness, floor wire harness, or ODS unit harness); replace the faulty harness, then clear the DTC.?
16. Reconnect the negative cable to the battery.
17. Turn the ignition switch to ON (II).
18. Measure the voltage between body ground and SRS unit connector B (39P) terminal No. 1. There should be less than 0.2V.
