7. Turn the ignition switch to ON (II), then wait for 10 seconds.
8. Clear the DTCs with the HDS.
9. Turn the ignition switch to ON (II), then wait for 10 seconds.
10. From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select SWS DTC CHECK.
Is SWS DTC 21-11 indicated?
YES -
Short to power in the ODS unit harness; replace the ODS unit harness, then clear the DTC. If the DTC does not clear, replace the ODS unit See:
Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/ODS Unit Replacement.?
NO -
Faulty outer side front passenger's weight sensor; replace the outer side front passenger's weight sensor See: Restraints and Safety Systems/Air Bag
Systems/Seat Occupant Sensor/Service and Repair, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the ODS unit harness 3P connector (A) from the outer side front passenger's weight sensor (B).
13. Turn the ignition switch to ON (II), then wait for 10 seconds.
14. Clear the DTCs with the HDS.
15. Turn the ignition switch to LOCK (0), then wait for 10 seconds.
16. Turn the ignition switch to ON (II), then wait for 10 seconds.
17. From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select SWS DTC CHECK.
Is SWS DTC 21-12 indicated?
YES -
Go to step 18.
NO -
Faulty outer side front passenger's weight sensor; replace the outer side front passenger's weight sensor See: Restraints and Safety Systems/Air Bag
Systems/Seat Occupant Sensor/Service and Repair, then clear the DTC.?
18. Turn the ignition switch to LOCK (0).
19. Measure the resistance between body ground and ODS unit harness 3P connector terminal No. 3. There should be an open circuit or at least 1
