Is the resistance as specified?
YES -
Go to step 11.
NO -
Open in the wire harness between ODS unit harness 18P connector terminal No. 12 and body ground (G605) (floor wire harness, or ODS unit
harness) or poor connection at G605; if the connection is OK, replace the faulty harness, then clear the DTC.?
11. Disconnect the negative cable from the battery, then wait at least 3 minutes.
12. Vehicles with ACC: Disconnect E-Pretensioner unit connector B(14P) from the E-Pretensioner unit See: Restraints and Safety Systems/Seat
Belt Systems/Seat Belt Tensioner/Service and Repair/Removal and Replacement.
13. Disconnect SRS unit connector B (39P) from the SRS unit.
14. Measure the resistance between body ground and SRS unit connector B (39P) terminal No. 1. There should be an open circuit or at least 1
MOhms.
Is the resistance as specified?
YES -
Go to step 15.
NO -
Short to ground between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7 (floor wire harness, or
ODS unit harness); replace the faulty harness, then clear the DTC.?
15. Measure the resistance between SRS unit connector B (39P) terminal No. 1 and ODS unit harness 18P connector terminal No. 7. There
should be less than 1.0 Ohms.
