Thursday, May 28, 2020

2010 Acura Truck MDX V6-3.7L Page 124


Is the voltage as specified?



YES -



Go to step 22.



NO -



Replace the appropriate suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and



Switches - Suspension/Ride Height Sensor/Service and Repair.?



22. Clear the DTC with the HDS.



23. Turn the ignition switch to LOCK (0).



24. Start the engine, and wait 5 seconds.



25. Check for DTCs with the HDS.



Is DTC 2-4 indicated?



YES -



Substitute a known-good active damper control unit and retest. If the DTC goes away, replace the original active damper control unit See: Relays



and Modules/Relays and Modules - Steering and Suspension/Relays and Modules - Suspension/Suspension Control Module/Service and Repair.?



NO -



Troubleshooting is complete.?



2-5



Active Damper System DTC Troubleshooting: 2-5, 2-6



DTC 2-5:



Right-front/Right-rear Suspension Stroke Sensor Range/Performance Problem



DTC 2-6:



Left-front/Left-rear Suspension Stroke Sensor Range/Performance Problem



1. Turn the ignition switch to LOCK (0).



2. Remove the appropriate suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and



Switches - Suspension/Ride Height Sensor/Service and Repair. Do not disconnect the sensor connector.



NOTE: After troubleshooting for the left side suspension stroke sensor, do the headlight initial position learning procedure See: Lighting and



Horns/Testing and Inspection/Programming and Relearning.



3. Start the engine, and wait 5 seconds.