Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?
4. Turn the ignition switch to LOCK (0).
5. Disconnect the negative cable from the battery, then wait at least 3 minutes.
6. Remove the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair, then disconnect the
dashboard wire harness 4P connector (A) from the front passenger's airbag.
7. Connect the SRS inflator simulator (2 Ohms connectors) and simulator lead J to the dashboard wire harness 4P connector.
8. Reconnect the negative cable to the battery.
9. Clear the DTCs with the HDS.
10. Check for DTCs with the HDS.
Is DTC 12-9x or 12-Bx indicated?
YES -
Go to step 11.
NO -
Short to ground in the front passenger's airbag first or second inflator; replace the front passenger's airbag See: Restraints and Safety Systems/Air
Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Front Passenger's Airbag Replacement, then clear the DTC.?
11. Turn the ignition switch to LOCK (0).
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
13. Disconnect SRS unit connector A (39P) from the SRS unit.
14. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the dashboard wire harness 4P
connector.
15. Measure the resistance between body ground and each terminals of both SRS simulator leads individually. There should be an open circuit or
