Is the resistance as specified?
YES -
Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, replace the
SRS unit See: Relays and Modules/Relays and Modules - Restraints and Safety Systems/Air Bag Control Module/Service and Repair/SRS Unit
Replacement.?
NO -
Short to ground in the floor wire harness; replace the floor wire harness, then clear the DTC.?
TPMS System
TPMS DTC Troubleshooting: 32, 34, 36, 38
DTC 32, 34, 36, 38:
Tire Pressure Sensor Signal Failure
NOTE:
- Inspect for an aftermarket electrical device(s) (such as an inverter, battery charger, CB radio, etc) interfering with the RF signal from the
sensors when turning the ignition switch is ON (II).
- Vehicle must be driven for 3 minutes at 15 mph (24 km/h) or more for DTC 32, 34, 36, or 38 to set.
1. Turn the ignition switch to ON (II).
2. Check the DTC indicated to the tire location to make sure the wheel is a TPMS type with the tire pressure sensor.
Is a TPMS type wheel with a tire pressure sensor mounted on the vehicle?
YES -
Go to step 3.
NO -
Install a TPMS type wheel, and memorize the sensor ID. Drive the vehicle above 15 mph (24 km/h) for 40 continuous seconds, or memorize the
ID with the HDS See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure Sensor/Testing and Inspection.?
3. Test-drive the vehicle.
4. Check the VEHICLE SPEED in the TPMS DATA LIST with the HDS.
Is the vehicle speed indicated?
YES -
Go to step 8.
NO -
Go to step 5.
5. Turn the ignition switch to LOCK (0).
6. Turn the ignition switch to ON (II).
7. Check for DTCs with the HDS.
